Removeable rubber tip. Connector actively locks on - won't come off until collar is lifted. 25mm dia is suitable for flushing hoses up to 7/8".

• Suitable for all Air Boy blow (and other) guns with an 8mm dia pipe.
• Actively locks onto the blow gun pipe.
• Non-marring rubber surface protects against scratching delicate surfaces.

The Air Boy thrust gun is ideal for cleaning tasks where high airflow is needed. The thrust nozzle increases the airflow by 100% because of the venturi principle - and is at the same time unblockable.

This gun is supplied with two nozzles - a standard nozzle, and a 90 degree nozzle (for blowing out filters etc). Both nozzles simply screw on, and are replaceable.

The pipe is fitted with insulation that protects the hands against cold air.

• 1/4" BSP inlet
• 1,000mm long pipe
• Air flow: 600 litres / min @ 8 Bar
• Working pressure: max 12 Bar
• Noise level: 98.2Db @ 8 Bar

A comphrehensive kit containing the I-Tester plus all necessary accesories to test:

- Relative compression via Current or Volts

- Synced compression test (allows you to know which cylinder(s) is low on compression.)

- Actual common rail fuel pressure sensor readings.

Kit includes:

• ET0090 I-Tester
• Inductive pick up clamp
• OBDII compression test adaptor
• 10:1 Voltage attenuator
• Back probe needles
• Alligator clips

The Air Boy 90 degree nozzle is now available in a new pushfit version. The function of the nozzle remains unchanged, but the pushfit connector makes it possible to remove the nozzle from the tip. The 90 degree nozzle is perfecct for cleaning out cylindrical filters etc.

The pushfit connector actively locks onto the blow gun pipe, and will not come off until the collar is lifted. Suits all 8mm dia Air Boy blow guns.

• Ideal for blowing out filters
• Works with all Air Boy 8mm dia blow guns
• Made in Denmark

Removeable rubber tip. Connector actively locks on - won't come off until collar is lifted. 25mm dia is suitable for flushing hoses up to 7/8".

• Suitable for all Air Boy blow (and other) guns with an 8mm dia pipe.
• Actively locks onto the blow gun pipe.
• Non-marring rubber surface protects against scratching delicate surfaces.

90 degree nozzles attach to all Air Boy blow guns. 90 degree airflow is ideal for cleaning filters and other similar applications.

• Simply screws on (but cannot be removed once attached)

A handy kit that adds functionality to Air Boy blow guns. Push fit design locks onto pipe.

Easily removed by lifting collar.

• Rubber tip for blowing out pipes, silent / unlockable, venturi for extra air flow, and 90 degrees for blowing out filters.
• Safety shield to protect against blow back.
• Suitable for use with all standard Air Boy blow guns (with 8mm dia pipe).

The Air Boy TURBO nozzle makes any Air Boy blow gun (with 8mm pipe) unblockable and increases airflow by 100%. The bypass nozzle makes it possible for the blow gun to absorb air through the sides, which provides for extra high airflow. The air also flows through the holes in the side, should the tip be blocked.

• 34mm overall length
• Suits any Air Boy blow gun with 8mm tube
• Cannot be removed once attached